Lippert In-Wall Slide-Out Wiring Harness | 35 ft, 6-Pin Controller-to-Motor

When an In-Wall slide-out stops responding, the wiring between the controller and the motor is a common culprit before you get to the motor itself. This is a genuine Lippert replacement harness only — the male-to-female, 6-pin controller-to-motor cable — not the motor assembly.

At 35 feet, it's built as an exact-match part with the same connectors as the original equipment, so installation is a straightforward swap with no assembly required.

• 35 ft length, male-to-female 6-pin harness
• Genuine Lippert replacement part
• Connects slide-out controller to motor (motor not included)
• Exact-match connectors for a straightforward install

Check your owner's manual to confirm this harness matches your specific In-Wall slide-out system before ordering.