Lippert 229756 In-Wall Slide-Out Controller-to-Motor Harness | 30 ft, 6-Pin, Male-to-Female

This Lippert harness carries the control signal from the slide-out controller to the motor on in-wall slide systems, replacing a damaged or corroded 30-foot run. It uses the same 6-pin male-to-female connection as the original Lippert wiring, so it's a straightforward swap rather than a full rewire.

• 30-foot controller-to-motor harness for in-wall slide-outs
• 6-pin connector, male-to-female
• Copper conductors
• Controller-to-motor harness only — does not include the controller or motor

Confirm your slide-out uses Lippert's 6-pin in-wall harness setup before ordering, since connector types vary across slide mechanisms.