Heng's Roof Vent Drive Gear | JRP1024B, 1/4" Thick, 1-5/8" OD

When a powered roof vent starts running rough or the fan stops turning with the motor still spinning, a worn drive gear is a common culprit. This replacement gear is sized to match the original Heng's JRP1024B spec.

• 1/4-inch gear thickness matches factory dimensions
• 1-5/8-inch outside diameter for correct fit
• Direct replacement for worn or stripped drive gears
• Sold individually for a targeted repair rather than a full assembly swap

A cheap fix that can save you from replacing the whole vent fan motor housing over one worn-out gear.