Valterra 22-1/2° DWV Elbow | 3" Hub x Hub, ABS

This Valterra elbow is built for RV and coach drain, waste, and vent (DWV) plumbing where you need a gentle 22-1/2 degree bend instead of a sharp turn. Both ends are sized for 3-inch hub connections, so it solvent-welds into standard ABS DWV lines run between holding tanks, vents, and drain fittings.

• 22-1/2 degree bend for gradual direction changes in DWV runs
• 3-inch hub x hub ABS construction
• IAPMO listed to ASTM-D2661-2011 and CSA B181.1-2011 standards
• Compact fitting works in tight underbelly or wall-cavity spaces
• Solvent-weld connection for a permanent, leak-resistant joint

Pair with matching ABS pipe and cement for a proper DWV repair or new plumbing run.