Dinosaur Electronics UIB 64 Universal Ignitor Board | Atwood Gas/Electric Water Heaters

The Dinosaur Electronics UIB 64 is a universal replacement ignitor board for Atwood AC/gas water heaters using a 6+4 pin connector setup. It runs on 12 VDC with fuse and surge protection built in, so a wiring hiccup at the pedestal or a voltage spike doesn't take out your water heater's electronics.

Three onboard diagnostic LEDs make troubleshooting straightforward, letting you see the board's status without pulling it apart to check for a bad connection or a failed ignition attempt.

• Direct replacement for Atwood 6+4 pin ignitor boards
• 12 VDC operation
• Fuse and surge protected
• 3 onboard diagnostic LEDs
• Board size: 3.25" x 4.25"
• TEI Certified

Confirm your water heater's connector configuration matches the 6+4 pin layout before ordering this board.